Labconco CentriVap Mobile System Model 7812002

$3,450
Manufacturer: Labconco Model: 7812002 CentriVap Mobile System Condition: Pre-owned Warranty: 30 day Test Performed: Listing ID# 38885

Specifications

• Epoxy-coated steel cabinet with injection-molded thermoplastic control panel
and four 2″ diameter hard rubber casters. Removable front panel provides
access to interior space for vacuum pump (sold separately).
• Tempered glass lid.
• Lid latch with safety sensor.
• Phenol-free lid gasket.
• Epoxy-coated cast aluminum chamber.
• 300-watt heater.
• Microprocessor-controlled programming for run time from 1 to 999 minutes,
heat from OFF to HI (100° C) in one degree increments, heat time from 1 to
999 minutes, cold trap on/off, and optional Heat Boost on/off. Memory stores
1 to 9 programs.
• LCD for display of program number, actual and set point temperature, heater
time remaining, run time remaining, cold trap activation and optional Heat
Boost activation. When the cold trap is activated the LCD flashes Y until the
collector coil reaches operating temperature of -40° C (-40° F) at which time
the Y glows continuously.
• Control panel with RUN/STOP button, PREHEAT button, COLD TRAP button,
optional HEAT BOOST button, set point SELECT button, increase/decrease
buttons, and 3 Quick-Start buttons.
• Centrifugal motion is provided by a brushless motor capable of achieving up
to 1725 rpm.
• Quick-Stop System to stop vacuum pump, open valve to bleed air into the
chamber and stop the rotor within seconds after time expires or RUN/STOP
button is pressed.
• Automatic vacuum release valve.
• Built-in vacuum delay allows rotor to achieve speed before applying vacuum.
• Audible alarm to signal completion of set point run time.
• 1/2″ OD aluminum hose fitting for connection to vacuum tubing.
Vacuum pump is not included.
• CFC-free refrigeration system with 1/4 hp compressor lowers cold trap to -55°
C (-67° F) in less than 15 minutes.
• 4-liter stainless steel collector with acrylic lid with two Quick-Disconnect
fittings for 1/2″ ID hose, rubber gasket and insulating cover.
• Front-mounted stainless steel collector drain port with nylon valve and grounding clip.
• Built-in clear canister to accommodate chemical trap insert. Cutout in front panel provides at-a-glance
trap monitoring.
• 115 volt models include a 115 volt electrical receptacle located on the back to connect accessory vacuum pump to
the system. A 6.5-foot, 3-wire cord and 20 amp plug are provided. A 20 amp minimum circuit breaker is required.
• Overall dimensions with closed lid: 13.75″ wide x 27.2″ deep x 37.9″ high
(34.9 x 69.1 x 96.3 cm).
• Actual weight 153 lbs. (69 kg). Shipping weight 165 lbs. (75 kg).

Request more information on this item:

  • This field is for validation purposes and should be left unchanged.
Copy link
Powered by Social Snap